Lec TS55184W, Руководство пользователя, Страница: 9 / 11

7
3. Excessive appliance noise level, Check:
- Make sure that the appliance is levelled correctly.
4. Appliance operation failure, Check:
- Make sure that the thermostat is not set to “OFF” or “0”
- Make sure that the power supply is not disconnected
- Make sure that the plug is inserted correctly into the mains socket
- Make sure that the automatic cut-out on the mains line has not tripped or that the fuse has not
broken.
- Make sure that the power cable is not faulty.
NOTE
If the power cable needs to be replaced, remove the plug from the power socket and install the new cable,
which must be requested from the Service Centre and installed by a qualified technician; ensure that it is
properly connected and fixed.
If problems persist after the above procedures, contact your nearest Technical Assistance department.
REVERSING THE DOOR
The door may be reversed in order to make installation more convenient.
We recommend that two people reverse the door, as the appliance requires
supporting whilst being tipped. Take care when fitting and tightening screws.
1. Remove the hinge cover (1) and the top hinge (2)
2. Lift the top door upwards to disengage it from the
middle hinge. Put the door to one side, laying it carefully
down on a padded surface.
3. Using a screwdriver, dismantle the middle hinge.
Lift the freezer door upwards to disengage it from
the lower hinge. Put the door to one side, laying it
carefully down on a padded surface.
4. Swap over the position of the lower hinge and the
adjustable leg to the other side of the cabinet.
5. Remove the hinge pins that is on the top of the fridge
door and the bottom of the freezer door. On the other side
of the fridge and freezer door, insert the replacement hinge
pin that is supplied with the appliance.
6. Place the freezer door on the lower hinge, making sure that
the hinge pin is inserted into the hole in the bottom of the
freezer door. Put the middle hinge back on the cabinet, making
sure that it is on the opposite side from its original position.
7. Place the fridge door on the middle hinge, making sure that the
hinge pin is inserted into the hole in the bottom of the fridge door.
Shut the door and then replace the top hinge. Ensure that the top
hinge pin is inserted in the hole at the top of the fridge door.
Replace the hinge covers.