7
SECTION 5: CARE & MAINTENANCE
Removing Table Cover/Cushion
It is recommended that you place the removable cushion from your table in a place where
it can air out on a daily basis. Simply remove the cover and cushion from the table and rest
the cushion on its side. See next page for detailed cleaning instructions.
Hydraulic System Maintenance
The stainless steel legs should be cleaned and lubricated often - this will help to maintain
smooth raising and lowering of your table. This should be done at least every 3 months or
more depending on frequency of use.
Cleaning Instructions:
1. Raise the table to its highest height position.
2. Spray WD-40 (or similar petroleum-based lubricant) on the legs, then use a lint-free
cloth to wipe the legs from top to bottom several times.
3. Check to see if any foreign material is stuck on surface. If needed, spray a thicker ap-
plication of WD-40 and leave for several minutes to help loosen most common debris/
materials. Wipe clean.
Lubrication Instructions:
1. Raise table to its highest position.
2. Using silicone grease, lubricate well on the exposed legs.
3. Raise and lower the table 2-3 times to distribute the lubricant.
4. Wipe off excess at leg bottom.
Water-Resistant Table Cover
Aquafoam™ Cushion