SECTION 4: CARE & MAINTENANCE
11
Cleaning Sanijet® Pipeless Jets
Preparation & Cleaning
1. Drain the bath of all water.
2. Rotate the jet covers to unlock. (Fig. 1)
3. Remove the jet covers. (Fig. 2)
4. Remove the magnetic impellers/rotors from the jet case. (Fig. 3)
5. Place the jet covers and impellers/rotors in a sink.
6. Use a non-abrasive antibacterial cleaner to remove any visible residue, and rinse with
fresh water.
7. Use a non-abrasive antibacterial cleaner to clean the basin, jet cases, drain stopper, and
light casing, followed by a rinse with fresh water.
Fig. 1
Fig. 2
Fig. 3
Disinfection
1. Spray surface of the jet covers, impellers/rotors, and basin until throughly coated with an
EPA-registered disinfectant.
2. Allow to set for the required disinfection contact period (refer to manufacturer specs).
3. Rinse surfaces with fresh water.
Re-Assembly
1. Dry the jet covers, impellers/rotors, and basin.
2. Reinstall the impeller (magnet will hold it in place).
3. Reinstall the jet cover by placing it at the 10 o’clock position. Maintain even pressure and
rotate jet cover to securely lock in place at the 3 or 9 o’clock position.
NOTE: You will feel the cover click into place.
Jets will not run if not locked into place properly.
- Always refer to your state/local codes for specific cleaning requirements.
- NEVER USE abrasive cleaners on any surface area. Failure to comply can
cause damage and void your warranty.
Foot Bath Additives
Provide an enhanced pedicure experience with essential oils, aromatherapy products, and other
additives, knowing all residue can be easily removed. The Sanijet® foot bath can be used with
most foot and skin care products, provided that the cleaning protocols are strictly followed.
Products NOT Recommended
•
Silicate based bath additives/scrubs - may void warranty.
•
High foam agents (use only low foam solutions).
•
Abrasive cleaners that might damage the system components, and scratch/dull the basin
surface (major scratches will require professional refinishing.
•
To avoid discoloration, products with petroleum distillates must not remain on surfaces.
Содержание Contour
Страница 19: ......
