CARE & CLEANING
Before cleaning your appliance
You should always unplug this appliance be-
fore cleaning.
To clean your appliance
• Clean the inside of the cabinet with warm
water and a neutral detergent, do not use
harsh abrasives or caustic cleaners.
• Dry the inside of the cabinet with a soft,
dry cloth. Always make sure the inside of
the appliance is dry after cleaning.
• Avoid getting water into the electric com-
ponents of the appliance (i.e. the thermo-
stat), or spilling water on the fridge.
• When cleaning the door seals, use only
warm soapy water. Please use a mild soap
and avoid damaging the door seal as this
will affect the performance of your appli-
ance.
• Clean the outside of the appliance with
warm,soapy water and dry with a soft
cloth. Any accumulation of dirt and dust
should be removed from the back and
bottom of the appliance to maintain ade-
quate ventilation.
• If the appliance is not in use for a long
period of time, you should clean the
appliance as detailed. Make sure that it is
dry,then unplug and leave the door open
to prevent unpleasant smells inside.
Please note: Regular turning off may short-
en the life of this appliance.
Important: Always unplug the appliance
from the power socket during cleaning and
maintenance.
• Never use any sharp instruments or abra-
sive substances, soap, household cleaner,
detergent or wax polish for cleaning.
• Use luke warm water to clean the cabinet
of the appliance and wipe it dry.
• Never clean the appliance with flammable
fluids. It could cause a damage and fire
hazard.
• Clean the exterior of the appliance and
door seal with a damp cloth and dry it
through.
• Avoid water goes in the temperature con-
trol box. Clean with a dry cloth only.
• Clean the condenser (located at the back
of the appliance) with a vacuum cleaner.
It is suggested to remove the dust every
year.
• Shelves are all removable for cleaning
purpose.
Light bulb replacement
Proceed the following to replace a failure
bulb:
1. Switch off at the socket outlet and pull
out the mains plug.
2. Remove the light diffuser cover by pulling
the recess at the edge.
3. Replace the bulb with a new 10 watt
(max) screw cap (SES) bulb.
4. Assemble the light diffuser cover and
switch on.