Now it’s time to start soldering! Flip over
your board so that the legs of your resistor
are sticking up in the air and turn on your
soldering iron. Be careful it will get hot!
Give yourself a length of solder, 4 to 6
inches. Then, holding the solder in one
hand and your soldering iron in the other,
use the tip of your iron to heat up both the
leg of the resistor and the gold ring around
the hole. Slowly feed in your solder into this
joint until you've made a solid connection.
Viola! One solder joint complete!
Do the same on the other leg of your
resistor then use wire snips or scissors
to cut the extra length of resistor leg
that is not needed. Be careful not to
cut too close or you might damage
your solder joint.
Follow the same process for Resistor 2
and Resistor 3.
Содержание Hue
Страница 1: ...Hue ...
