Tighten the bolts to 22.0Nm torque for concrete.
Tightening the bolts will fan out the bolt sheath
in the hole holding the bolt secure.
Using a mallet drive the bolts home.
Re-position the bin over the drilled holes. Add
washers to bolts and push through moulded
holes locating into drilled ground holes beneath
Replace liner and hood. With hood resting on base
rotate hood clockwise until it will rotate no
further. Push lock in to engage
Remove the ballast from the bottom of the bin.
Remove the plug and fill with a suitable material.
Spread the ballast material by hand or by tipping
the base in order to reinsert ballast plug as
shown.
Replace liner and hood. With hood resting on base
rotate hood clockwise until it will rotate no
further. Push lock in to engage
