Leader LV 5333, Инструкция по эксплуатации

Страница: 128 / 239

12. VECTORSCOPE DISPLAY
116
VECTOR → F•5 EXTREF PHASE → F•5 USER REF SET
12.9.2 Selecting the Memory Number
You can save up to eight sets of phase differences between the SDI signal and the external
sync signal. You can use this when you need to switch systems using a switcher or the like
and align the phases.
To select the memory number you want to save to or delete the contents of, follow the
procedure below.
Procedure
12.9.3 Saving the Phase Difference
To save the phase difference between the SDI signal and external sync signal to the memory
number selected with
SDI NUMBER, follow the procedure below.
Procedure
12.9.4 Deleting a Phase Difference
To delete the phase difference from the memory number selected with
follow the procedure below.
Procedure
SDI NUMBER,
12.9.5 Setting the User-Defined Phase Difference Reference
To set the phase difference between the SDI signal and external sync signal to zero, follow
the procedure below..
You can change the reference to match the system that you are using.
Procedure
12.9.6 Setting the Phase Difference to Default
To set the phase difference between the SDI signal and external sync signal to the default
value, follow the procedure below..
When set to the default value, the phase difference is assumed to be zero when an external
sync signal without a timing offset transmitted from a LEADER signal generator and an SDI
signal are received. (Depending on the output accuracy of the signal generator and
measurement accuracy of the LV 5333, there may be an offset of around ±3 clocks in the
display.)
Procedure
VECTOR → F•5 EXTREF PHASE → F•6 REF DEFAULT
VECTOR → F•5 EXTREF PHASE → F•3 MEMORY CLEAR
VECTOR → F•5 EXTREF PHASE → F•2 SDI MEMORY
VECTOR → F•5 EXTREF PHASE → F•1 SDI NUMBER: 1 - 8
F•1
F•1