1
The LSG/DMX Interface will allow the user to control the LSG, or any other 115
Volt load that is 10 Amps or less, using a standard 512 DMX signal.
Using The LSG/DMX Interface
Auxiliary Output # 1& 2
Main Power Switch
Manual Override
DMX Data In / Out
These outputs are 115 Volts and are switched on and off using the DMX Signal.
Each Output is
10 Amps Maximum, with a Maximum combined load of 12
Amps .
Output 1 is DMX Channel
(
n
)
. Output 2 is DMX Channel
(
n+1
)
. Output 2 is
always the next consecutive higher channel than Output 1.
This switch is used to turn on the Main Power.The switch is illuminated when in
the
On
position
This switch is used to manually activate Auxiliary Output #1. When switch is
turned on the switch will be illuminated and there will be 115 volts power
present at Auxiliary Output #1
Green Led
Yellow Led
DMX Addressing Dip Switch
These two 5- pin connectors recieve, and throughput the DMX Data. They are
wired per the DMX 512 Protocol, and the pinouts are available on page two.
The green led will indicate if power is present at the DMX circuit board.
Uses binary addressing to address
both DMX channels used on
Auxilliary Outputs 1 & 2.
DMX setting
n
is the first output.
DMX setting
n+1
is the second
output.
The yellow LED indicates the pres-
ence of DMX signal. A solid Yellow
LED indicates that the unit is
recieving the DMX signal.
Содержание DMX Interface
Страница 1: ...LSG D M X Interface Users Guide ...