37
4. Press AUX2 to set the switch to Out position
Accessory Configuration Examples
To program your ASC2 for operating up to eight lights and/or accessories on IDs 9-16:
1. Turn power to your command base and LCS system on.
2. Press and hold the ASC2 PGM button for 1 seconds. The red LED will begin blinking slowly.
3. On your Lionel cab remote, press ACC to choose Accessory configuration.
4. Press the 9 key (this will be the base address/TMCC ID).
5. Press SET. The red LED will blink quickly, then return to slow blinking.
6. Press AUX1
7. Press the 0 key. This sets Eight ID sub-mode.
To operate the second connected accessory:
1. On your Lionel cab remote, press ACC to address an Accessory.
2. Press the numeric keys 1, then 0. (the TMCC ID of the second accessory, base address
plus 1).
3. Press AUX1 to turn the accessory on for as long as the button is held., OR
4. Press and release AUX2 to turn the accessory on and again to turn it off.
To program your ASC2 for operating up to eight uncoupling tracks, all responding to TMCC ID
17:
1. Turn power to your command base and LCS system on.
2. Press and hold the ASC2 PGM button for 1 seconds. The red LED will begin blinking slowly.
3. On your Lionel cab remote, press ACC to choose Accessory configuration.
4. Press the numeric keys 1, then 7 (this will be the base address/TMCC ID).
5. Press SET. The red LED will blink quickly, then return to slow blinking.
6. Press AUX1
7. Press the 1 key. This sets Single ID sub-mode.
To operate the fifth connected uncoupling track:
1. On your Lionel cab remote, press ACC to address an Accessory.
2. Press the 1, then 7 key (the TMCC ID base address).
3. Press the 5 key to operate the fifth connected track piece.
Appendix
