LCI Power Tongue Jack, Руководство по установке

Страница: 4 / 8

Rev: 10.23.19
Page 4
CCD-0001562
Installation
1.
Carefully slide the jack leg (Fig. 2A) through the hole in the coupler (Fig. 2B) on the trailer A-frame
(Fig. 2C).
2. Align the three holes in the Power Tongue Jack mounting plate (Fig. 3A) with the three holes in the
coupler (Fig. 3B).
3.
Secure the Power Tongue Jack to the coupler plate with the three required 3/8" - 16 x 1” hex bolts (Fig. 4A).
4.
Connect the red power wire from the Power Tongue Jack housing to a grounded 12V power supply
on the trailer.
Note:
The Power Tongue Jack must be wired through a 30 amp fused circuit.
Fig. 3 Fig. 4
A
B
A
Fig. 2
A
C
B
D
All electrical wiring harnesses shall be loomed and secured to prevent possible damage and
installed in accordance with RVIA electrical standards.
5.
Loom the harness wires (Fig. 2D) with the appropriate size and length to protect the wires from damage.
6.
Reattach the footpad to the jack leg by sliding the foot pad back over the bottom of the jack leg and
securing it with the clevis pin and hairpin cotter pin previously removed (Fig. 1).