1. How to use and charge the LED
1
LED
This LED complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
The LED in this box is compatible
with one of the follwoing helmets
only: Lazer Lizard, Lazer Cameleon,
Lazer Gekko, Lazer Lil’Gekko, Lazer
Urbanize.
The LED will need to be charged fully
before use: Using the cable provided,
plug the LED in to a standard 5V.
To charge, use a USB power source
(smartphone charger or computer USB
port) from a renowned manufacturer.
Charge for approximately 2 hours to
fully charge the light. During charging
time, the battery signal led will turn
solid red and when it is 100% charged,
the charging LED will go out.
After approximately 8 hours of use
on constant mode you will need to
recharge your battery.
To do this you will need to remove
it from the helmet.
1. Constant
Run time 8 hours
2. Flashing
Run time 26 hours
3. Pulsing
Run time 10 hours
4. Off
1- STILL MODE
2 - FLASHING MODE #1
3 - FLASHING MODE #2
4 - FLASHING MODE #3
5 - OFF
battery
battery insulator
battery
1- STILL MODE
2 - FLASHING MODE #1
3 - FLASHING MODE #2
4 - FLASHING MODE #3
5 - OFF
battery
battery insulator
battery
1- STILL MODE
2 - FLASHING MODE #1
3 - FLASHING MODE #2
4 - FLASHING MODE #3
5 - OFF
battery
battery insulator
battery
1- STILL MODE
2 - FLASHING MODE #1
3 - FLASHING MODE #2
4 - FLASHING MODE #3
5 - OFF
battery
battery insulator
battery
Light modes:
1)
To turn the light on, simply short
press the logo on the front of the light.
To cycle between the light modes short
press the same button. To turn of the
light, cycle through all light modes until
the light is off.