LS-CS-M0005-EN
LZS-003-HS Operation Manual – Dual Laser Version
Page 33
Version 1.11
Released: 03/12/2007
7
7
.
.
4
4
N
N
e
e
w
w
P
P
a
a
s
s
s
s
w
w
o
o
r
r
d
d
As described in the previous section, it is strongly recommended that you change the
parameter programming password as soon as the LZS-003-HS is installed. This specifically
prevents unauthorised access to Field Muted mode, in which there is no laser protection.
Note:
For your convenience, it is important to record the new password and save it in a
safe place. If you lose the password, the operator panel must be returned to Lazer
Safe or your authorised distributor / installer to have the default password restored.
After entering this programming parameter, the display shows:
Figure 7-9: Enter new password
To enter a new password:
1. Press the
Field Muted
button to increment the current digit (highlighted with an
underscore) or press the
Guard Mode
button to decrement it.
2. When the correct value for that digit is displayed, press the
Mute Stop
button to select the
next digit.
3. Repeat Steps 1 and 2 until all four password digits have been entered. At any time, you
can go back to previous digits by pressing the
Mute Stop
button until it "scrolls" back to the
position you wish to change.
4. Press the
SET
button to accept the value entered.
Once all four digits have been re-entered, you will be prompted to re-enter the password to
confirm it, as shown:
Figure 7-10: Re-enter new password
