LaZee Tek
Computer Access Technologies
4 of 5
224-H
4.0 Setup
1.
On host computer reduce mouse speed settings. Adjust as needed to match user’s proficiency.
Good starting point: maximum speed of 5 seconds for cursor to travel from Left to Right side
of monitor. Menu located: Start Menu / Settings / Control Panel / Mouse / Mouse Properties /
Pointer Options . Similar menus are available in other operating systems.
2.
Determine appropriate placement of eeZee Mouse.
3.
Set Range of Motion (ROM) adjustment to mid point or above, depending on users abilities.
4.
Connect the Body Body Sensor connector to the Body Sensor input jack. Position Body
Sensor in desired operating position on user’s head, foot, or anywhere in between!
a.
Body Sensor must be oriented so as the cable exits toward the rear.
b.
Body Sensor must be attached firmly to activating surface.
c.
Attach Body Sensor cable clip to support cable.
5.
If desired, connect switch to external HOME input jack.
6.
Connect small end of USB cable to eeZee Mouse.
7.
Using standard ESD precautions connect large end of USB to host computer.
a.
First time eeZee Mouse™is connected to computer, it may be recognized as New
Hardware. If so, wait several seconds for the “New Device Ready for Use” message.
b.
Ignore cursor movements until Step 2 below.