Power Ease
TM
Motion Sofa
Assembly Details:
F
IGURE
2
F
IGURE
3
Transformer
Cord Locking
Cover
F
IGURE
1
Power Transformers
& Transformer Cords
Lower Rear Rail
Motor
Connector
Transformer
Cord
Connector
F
IGURE
4
F
IGURE
5
Power
Transformer
with Battery
Backup
Power
Transformer
Transformer
Cord
Connector
Power Ease
TM
Motion Sofa
Assembly Instructions:
-
To reduce the risk of injury.
•
Do not operate the unit until the backs are installed and locked.
CAUTION:
Do not plug the transformers in until instructed.
Assembly Instructions for Power Ease
TM
Motion Sofas
1. Locate the two Power Transformers and the two Transformer Cords.
•
The Power Transformers and the Transformer Cords are secured to the
lower rear rail of the sofa. Carefully cut the cable ties and remove the
Power Transformers and the Transformer Cords from the rear rail
(F
IGURE
1). Remove the packing and unwind the cords.
2. Install the backs. Proceed to Step 3 if your Power Ease
TM
Motion Sofa came
with the backs attached.
•
If your sofa backs have upholstery cover attached to all sides of the
back frame, follow the Back Assembly Instructions on pages 10-11.
•
If your sofa backs have a loose upholstery cover with fastening tape,
follow the Back Assembly Instructions on pages 12-13.
3. Connect the Transformer Cords to the motors.
•
Locate the motor connectors behind the end sofa seats (FIGURE 2).
•
Connect each Transformer Cord connector with the motor connector.
Push the connectors together until they are secured, with no gaps
between them (F
IGURE
2).
•
Rotate the Transformer Cord Locking Cover over this connection and
snap in place (F
IGURE
3).
4. Connect the Power Transformers to the Transformer Cords.
•
Connect the Transformer Cord two prong connector with the Power
Transformer receptacle. Make sure the connection is secured, with no
gaps (F
IGURE
4).
•
Repeat to connect the remaining Power Transformer and Transformer Cord.
5. Choose a location for the sofa that is close to an electrical outlet. Proceed to the
Battery Backup Assembly Instructions.
-
To reduce the risk of injury.
•
Replace the power transformer batteries every six months and after each
power failure use.
Batter y Backup Assembly Instructions for Power Ease
TM
Motion Sofas
The Battery Backup is located in the Power Transformers and uses two 9-volt
alkaline batteries each (not included).
1. Unplug the Power Transformers from the electrical outlet.
2. Remove the Phillips head screw from the battery cover plate on top of the
Power Transformer. Push the tab in and lift to remove the cover plate.
3. Place the connection caps over the battery terminals on each battery. Place
the batteries in the Power Transformer (F
IGURE
5). Snap the battery cover
plate into place and secure with the Phillips head screw removed in Step 2.
4. Repeat above steps for remaining Power Transformer.
5. Proceed to the Power Ease
TM
Operating Instructions.
WARNING
WARNING
9
8
