mc²36 MKII Installation & Service Guide
Version: 1.0/1
40/56
5. Service Procedures
5.6
Replacing a TFT Display
Each of the touch-screen displays can be replaced without affecting the rest of the system.
If you need to replace the centre section display, then connect an mxGUI computer so that it can run online
and provide continued access to central GUI operations.
DO NOT
attempt to open the frame without first disconnecting the mains supply.
1.
Unfasten the three screws at the top of the display using a long T20 Torx driver, and gently tilt the unit
forwards:
The Torx driver shaft
MUST
be long enough to turn the countersunk screws without scratching the front
panel. If you attempt to use a short driver, or driver attachment, damage can occur.
2.
Remove the connectors, taking note of where each one should be fitted.
Each display has 1 x Display Port, 1 x USB and 1 x power connector.
3.
Carefully remove the display by lifting it out of the frame. Lay it it face-down on a piece of foam, or
similar ESD-proof protective material, away from the console.
4.
Fit the replacement in the reverse manner.
Once the control surface is powered, the display will refresh within a few seconds.
5.
the bay's server to refresh the communication with the control system.
The touch-screen displays are calibrated before leaving the factory and require no further calibration by the
customer.
