mc²36 MKII Installation & Service Guide
Version: 1.0/1
31/56
4. Installation
To fit protective covers with a fastening cable, attach the cable to the top left screw as shown below. The
blanking plate has its own screw which must also be used.
The stickers showing the cable specification should be positioned centrally above each port.
Rear Connector Panel (with stickers)
4.15
External Synchronization
Console Rear Panel
The
CLOCK IN
can be used to connect an external sync reference. The input accepts Wordclock only. When
running the system referenced to Wordclock, the frequency of the sync source MUST match the internal
operating sample rate of the system.
The
CLOCK OUT
provides a Wordclock out of the current system clock.
Both connections use a standard 75 ohm BNC connector. The maximum cable length depends on the
equipment you are connecting to.
