2. Connecting and installing the base station
Refer to Assembly section in the Instruction Manual
1) Peg the starting end ( ) of the boundary wire into place at position 1 as illustrated (close to
the terminals at the rear of the base station), leaving 20cm length for connection later.
2) Install the boundary wire anti-clockwise around the lawn as described above.
3) Run the end ( ) of the boundary wire through the slot under the base station, leaving 20cm
length for connection later.
1
1
2
2
2
20cm
20cm
1
3
4
5
6
4) With the wire stripper provided, strip 10-15mm of insulation material from the ends of the
boundary wire for connection to the base station.
5) Before connecting the boundary wire to the base station, ensure the base station power supply
is disconnected from the mains.
6) Insert the wire ends into terminals at the rear of the base station. Run the starting wire ( )
through the hook (C) of the base station and connect it to the red terminal (A), the end of the
wire ( ) that runs under the base station connects to the black terminal (B).
1
2
B
C
A
1
2
7) Attach the base station to the ground, and secure it with the supplied four screws.
8) If the mower has not already been charged while the boundary wire was laid, connect the base
station’s power cord to the power adaptor.
9) Connect the extension cable to the power adaptor. Position the power adaptor and the
extension cable on the ground as shown to protect from water.
10) Connect the extension cable to a 100-240V wall socket. If the power supply is connected to
an electrical outlet outdoors, make sure the electrical outlet is always in a dry place and the
wattage is compatible with the mower.
11) If the mower has not already been charged while the boundary wire was laid, place the robotic
mower in the base station to charge the battery before first use.
3. Starting and stopping
Refer to Operation section in the Instruction Manual
1) Press the On/Off switch to the “I” ON position.
2) Open the top hatch to reveal the control panel.
3) To unlock the mower, press the UNLOCK button until you hear a beep sound, and then input
the security code by pressing the corresponding time setting button of each digit ( ). Press
the OK button. The control panel is unlocked.
NOTE:
The default security code is 2323. To change security code, please refer to the
instruction manual.
4) To start the mower, unlock the mower and then immediately press the Start button. The robotic
lawnmower will begin to mow. The default daily working schedule includes 8 hours of working
time (mowing and charging included), and 16 hours on standby on the base station.
5) When recharge is required, the robotic lawnmower will follow the boundary wire to return to the
base station. It takes around 40~45 minutes to be fully charged. Then the robotic mower will
resume mowing. When the 8 hours of working time is over, it will return to the base station and
remain on standby on the base station for the working schedule next day.
6) To stop the mower manually during operation, press the STOP button.
7) To turn off the mower, press the On/Off switch to the “O” OFF position.
NOTE:
If the mower On/Off switch has been turned to the “O” Off position, the mowing schedule
has been interrupted and must be re-set according to instructions in the following section Adjust
the mower to suit your lawn.
1
1
4H
2
6H
3
8H
4
10H
OK
Start
1
4H
2
6H
3
8H
4
10H
OK
Start
1
10-15mm
Содержание L10
Страница 3: ......
