LawnMaster GV1314, Руководство оператора

Страница: 16 / 28

16
To set the work positions:
■ Check that the tool is turned off before adjusting the working position.
■ Hold the tool, and pull up the height adjustment lever. Turn the lever as appropriate and push it down to
snap in (Fig.9).
NOTE: The height adjustment lever is not intended for
height adjustment but rather to compensate for wear.
Selection of a readjustment position without the
corresponding wear can overload the motor and damage
the cylinder.
OPERATION
WARNING
WARNING
Do not use any attachments or accessories not recommended by the manufacturer of this product.
The use of attachments or accessories not recommended can result in serious personal injury.
Do not switch on the tool until it has been completely assembled. Before switching on the tool, always
check the power cord for signs of damage. Only use an undamaged power cord.
NOTE:
A damaged power cord is highly dangerous!
The tool has 4 principal position settings:
Transport position ( )
This position sets the maximum safety spacing between the tool and the floor.
Working position (1)
Set this position when working with a new tool.
Readjustment working positions (2 & 3)
The working position can be lowered with increased knife and spring tine wear. Wear can be identified
from an increasingly poor result.
NOTE:
When the tool is delivered, it will be set in in the transport position.
SETTING THE WORKING POSITIONS
Fig. 9