LAWN STAR LSGS 2800, Руководство по эксплуатации, Страница: 6 / 11

6
ASSEMBLY OF SHREDDER
Note: Assembly of the shredder requires two people.
Fitting the wheels and feet: Fig.A No.5
You may need assistance when lifting the machine out of the box and assembling.
1. Turn the frame upside down and place it on the floor (Fig. 2).
2. Position the axle tube between the two legs of the frame (Fig. 2).
3. Position the small washer (Fig.1 No.5), wheel bushes (Fig.1 No.3), wheel, big
washer (Fig.1 No.6) and nut (Fig.1 No.4) as shown in figure 1. Do this for both
wheels. Tighten both the wheel nuts using a suitable spanner. Note: The wheels
must be fitted correctly to allow the nuts to tighten on each end of the axle.
4. Push the wheel hubcaps firmly onto the wheels (Fig.4 No.2).
5. Fasten the 2 feet to the frame
– each foot required 2 washers and 2 screws
(Fig.12). Push the cap on the foot.
6. Turn the assembly onto its wheels and feet (Fig.5).
Fitting the motor and gear unit: Fig 6
1. Position the upper shredder unit on the frame
– ensure the inlet feeder (Figure A
No.1) is located above the end of the frame with the wheels.
2. Place the 4 washers and then fasten the screws provided (Fig.6) in the corners of
the shredder unit.
Fitting the Collection box: Fig. 7 to 9
1. Ensure the locking handle for the collection box is down (Fig.8).
2. Push the collection box in the frame under the upper shredder unit (Fig7). Ensure
the collection box is fully inserted.
3. Push the locking handle up to secure the collection box (Fig.9). The locking handle
activates a safety switch. The garden shredder can only be switched on when the
locking handle is in the upwards position.
11
Pressure
plate
10
12
Foot
Washer
Screw
Cap
Some units have been fitted with a dial
adjustment mechanism and alum key is
not required