EN
27
Problem
Solution
1. The brakes
doesn't work
properly
1. Clockwise to switch the nuts on both sides of the tire to adjust the brakes
and the both sides bake balance until the brake works well.
2. Can not
walking
2. Associated parts: Controller, fuse, Bidirectional contactor
(Below the fuse), accelerator, Driving wheel (Front wheel),battery,
Corresponding wiring terminal connectors. Any one of the components
is damaged or has poor connecting will probably causes this problem.
Please check the above components or connecting then to replace the
damaged parts then the machine can walk again.
3. Not sweeping 3. Please check the components of the sweeping system. The relative
components: 2 brush motors,1 roller brush motor, 1 Fan, 1 * 100A
contactor, Limit switch, push levelers of roller brush and side brush, steel
cable, and sweeping switch. Sweeping switch is damaged or not well
connected, roller brush's push leveler damaging, or break of steel cable,
may occurs to the no sweeping function. Also please check the motors
if one of it doesn't work. If it is, please repair or replace this motor. If all
the motors doesn't work, may have the problems as follows
Please check if the key switch of the sweeper out of work. If it is, replace the
key switch
Travel Limit switch doesn't work. Adjust the roller brush wire rope to make
the travel limit switch work; if the travel limit switch is found to be
damaged, replace it.
4. The water
doesn't spray
4. Please check the spray system related parts: Water tank, water pump,
water pipe, valve, spray nozzle, relay, switch and control circuit. Some
problems may occurs this problem such as water tank leakage, water
pipe breaking, knotting loosing, clogging of the water nozzle, the water
pump breakdown, and electrical circuit failure.
5. Dust shaking
doesn't work
5. Check if Dust Filter motor is damaged; if the dust chain is loose or broken;
If the electric circuit and switch button doesn't work. If damaged, repair
or replace it.
6. Doesn't
charging
6. Check if the charger connector is connected properly. If not, please
reconnect it or plug it in. Check if the charger is working well. If not,
please repair or replace the charger. If other problems may happen,
please contact the after-sales in time.
16
TROUBLESHOOTTING
Содержание SWL R 950
Страница 2: ...2...
Страница 96: ...cod 7 700 0628 rev 01 Lavorwash S p A via J F Kennedy 12 46020 Pegognaga MN ITALY...