Lavorwash INDO, Инструкция по эксплуатации

Страница: 20 / 108

20
IDENTIFICATION OF COMPONENTS
Refer to Figures 1 to 5:
1. ON/OFF Master switch
2. Handle
3. Lance support
4. Warning plates. Inform on residual risks and PPE
to be used
5. Identification plate. Indicates the serial number,
guaranteed sound power value (in compliance
with Directive 2000/14/EC) and main technical
characteristics
6. Power cable
8. Pressure adjustment knob
9. Handle securing screws (INDO)
10. Handle securing washers (INDO)
12. Handle securing nuts (INDO)
13. Pressure indicator
14. Oil plug with vent and dipstick (INDO)
16. Water outlet fitting
17. Water inlet fitting
18. Water inlet filter
20. Wheel brake
21. START push button (LENA)
22. Spray gun lever
23. Spray gun lever safety stop
24. Spray gun
25. Water inlet hose-end fitting
26. Gasket for water inlet hose-end fitting
27. Water inlet filter cartridge
28. Water inlet filter cap (INDO)
29. Lance hose
30. Nozzle holder head
31. Nozzle cleaning pin
35. High pressure hose
36. High pressure hose quickfit coupling
40. Emergency push button (LENA)
41. Relief valve (LENA)
42. STOP push button (LENA)
43. Mains voltage LED
47. Lifting point
48. Thermostatic valve (LENA)
49. Hour counter (LENA)
50. Oil sight indicator
60. Lance hose adjustable handle (LENA)
63. Water inlet filter clamp
66. Oil plug with vent (LENA)
SAFETY DEVICES
• Automatically (INDO) or manually (LENA) resettable ampere cut-out protection.
These devices stop high pressure cleaner operation in the event of excessive power absorption.
In this case, proceed as follows:
Automatically resettable ampere cut-out protection (INDO)
- move the master switch (1) to “0” position and remove the plug from the power socket;
- press the spray gun lever (22), so as to release any residual pressure;
- wait 10÷15 minutes for the high pressure cleaner to cool down;
- make sure the instructions for connection to the power supply are complied with (refer to the
Instruction manual – Safety precautions), with special reference to the extension used;
- fit the plug back in the socket and repeat the start procedure described in the paragraph “Operation”.
Manually resettable ampere cut-out protection (LENA)
- move the master switch (1) to “0” position and remove the plug from the power socket;
- press the spray gun (24) lever (22), so as to release any residual pressure;
- have a Specialized Technician check the high pressure cleaner because the device has to be reset
manually and to do this it is necessary to access the inside of the electrical panel.
• Pressure unloader/regulation valve.
Valve, suitably calibrated by the Manufacturer, for regulating work pressure by means of the knob (8)
and that allows the pumped fluid to return to pump suction thus preventing the onset of dangerous
pressures, when closing the spray gun or when trying to set a pressure that is above the maximum
permitted values.