LAVAZZA blue LB 1200 USA CLASSY PRO 120V, Руководство по обслуживанию

Страница: 13 / 54

Technical support maintenance manual
Rel. 0.00 / February 2020
9
7.2.1.1. RECIPES
Viewing and editing of data relating to the delivery of
the drinks.
Espresso temp.
Parameter allows you to adjust three temp. levels for
the espresso:
- Low
- Medium
- High
Note
By factory default, the unit is set to the “High” value.
Product volume in OZ.
This parameter allows the setting of the dose of each
drink (min 0.6 oz / 20 ml up to max 8 oz / 240 ml).
- ESPRESSO
- LUNGO
- COFFEE 8 OZ.
- MACCHIATO
- CAPPUCCINO
- LATTE
7.2.1.2. CARE
Displaying and enabling the processes of cleaning and
maintenance.
Descaling
The ” Descaling ” function is composed of a further sub-
menu that allows you to view statistics for descaling and
start the cycle.
Cleaning
The ” Cleaning ” function allows you to start the wash
cycles of the unit.
A) Frother rinsing
B) Brew unit rinsing
C) Clean milk spout
D) System filling
A) FROTHER RINSING
Start washing the milk module.
Warning
The FROTHER RINSING must be carried out after
each preparation of a milk based beverage.
- Insert one end of the milk tube into the hole on the drip
grid.
- Place a large container under the dispensing spout
and press the MULTIFUNCTION key.
- The unit starts rinsing.
- At the end, the procedure is finished.
B) BREW UNIT RINSING
Start washing the dispenser Assembly.
Press the MULTIFUNCTION button to confirm.
Water leaks from the Assembly.
C) CLEAN MILK SPOUT
Start washing the milk tube.
- Place near the unit a container full of drinking water,
either uncarbonated or of a specific detergent.
- Insert the end part of the milk tube inside the container
and press the MULTIFUNCTION button.
- The unit initiates the cleaning cycle.
- At the end, remove the tube from the container and
insert it into the hole on the drip grid.
- Press the MULTIFUNCTION button to start rinsing.
D) SYSTEM FILLING
The function allows you to start filling the water circuit if
the circuit is not full.
Press the MULTIFUNCTION button to confirm.
7.2.1.3. SETTINGS
Displaying technical specifications of the unit and set
-
ting the Stand-by and Eco mode.
Unit information
Reading of the production data of the unit.
- Software version
- Date of production of software
- Version number of development environment
- Serial number