LAUNCH
33
6.22 High Voltage Battery Detection (HIGH VOLTAGE BATTERY)
This function is used for high voltage battery diagnosis and status information detection.
6.23 Windows Calibration
This function is used to perform door window matching to recover the ECU initial memory, and recover
the automatic ascending and descending function of power window.
6.24 Language Change
This function is used to change system language of vehicle center console.
6.25 A/F Reset
This function is applied to set or learn air/fuel rate parameters.
6.26 Transport Mode
To lower vehicle power consumption, user may perform the following operations: limit vehicle speed,
not wake up the network for door open and disable remote key etc. In this case, deactivating transport
mode is needed to recover vehicle being normal.
6.27 Stop/Start Reset
This function is used to open or close the automatic Start/Stop function via setting the hidden function
in ECU (The precondition is vehicle equipped with hidden function and hardware support).
6.28 Intelligent Cruise Control System Reset
This function is used to matching the intelligent cruise control module after it is replaced or repaired.
6.29 Engine Power Balance Monitoring
This function is used to monitor crankshaft acceleration in the power stroke of each cylinder, to
determine the relative power provided by each cylinder.
6.30 Gas Particulate Filter (GPF) Regeneration
This function is used to perform the GPF replacement or regeneration after the fuel consumption is
increased and engine output power is reduced resulting from a long time service of the GPF.
6.31 Motor Angle Calibration
This function is used to perform the motor angle calibration when the rotor position detected by the
motor angle position sensor is different from the actual rotor field position.
6.32 Tire Pressure Reset (TPMS RESET)
This function can reset the tire pressure and turn off the tire pressure fault indicator when the car tire
pressure fault indicator light is on.