Launch TWC-581, Инструкция по установке и каталог запасных частей

Страница: 8 / 32

LAUNCH Tire Changer TWC-581
8
Installation of Tool box
Install the tool box on one side of the cabinet
according to figure 14.
Fig.14
Transportation
It is advisable to transport the machine with fork lift
vehicle.
Movable parts such as the assist arm assembly,
swing arm assembly, bead breaker arm assembly,
must be fastened to the cabinet tightly with rope
to avoid damage to machine and injuries to
people during transportation.
Avoid excessive tilt in transportation.
Don’t drive the fork lift vehicle carrying the
equipment too fast.
Keep the machine at as low a position as
possible and make sure it doesn’t overturn in
transportation (pay attention to the position of the
gravity center).
Positioning
The place to install the machine should be in
accordance with safety regulations:
The machine should be installed in a place close
to the main power and compressed air source.
Install the machine on a smooth concrete floor or
other surface with hard flooring. 4 sets of
anchor bolts (M10×150) can be used to fasten
the machine onto the floor to avoid vibration and
noise.
Leave enough space around the machine for
proper operation and maintenance. The space
should be no less than 1M (39”) in front and on
the two sides of the machine and 0.75 M (29”)
behind it.
If the machine has to be installed outdoors, a
protective shelter should be built.
Note:
For the safety and proper operation, keep the
machine at least 0.75M (29”) away from any wall.
Power and Air Connections
Before installation, verify the electrical power
source and the compressed air are in
accordance with the specifications on the
nameplate. Any electrical connection should be
performed by a specially trained technician.
The power socket should be at a place within the
sight of the operator. The advisable height is
between 0.6 – 1.7M. (24”-65”)
In case the main voltage is not stable, a voltage
stabilizer should be used between power source
and the machine.
The machine should be well grounded.
The tire changer is not equipped with
overload protection. Please connect power
according to the circuit diagram included in the
User’s manual. Otherwise, the manufacturer
will not be responsible for any accidents.
Adjusting
Attention:
Make sure that the power supply, air
sources and the oil level in the oil cup are in
accordance with the requirements.
Initial Operation (Fig. 01-1)
Note:
The four pedals must be kept at the original
position.
Press down the pedal (J) to turn the turntable
clockwise;
Lift the pedal (J) to turn the turntable
counter-clockwise;
Press down pedal (I) to move bead breaker;
release it to restore;
Press down pedal (H) to move the jaws on the
turntable outward; pedal again to move them
inward;
When the up down control lever is lifted, the
assist arm device will go up.
When the control lever is lowered down, the
assist arm device will go down.
When the Inflation pedal U Fig.01-1 is lightly
pressed, air will blast from the air hose
connected with the barometer (mounted on tool
box). When the pedal is pressed down to the
lowest position, air will quickly blast out from
behind the four jaws (the end of the slides)