Launch TWC-502RMB, Руководство пользователя

Страница: 9 / 34

LAUNCH Tyre Changer(TWC-502RMB)
8
the motor and the turntable will both turn
counter-clockwise.
l If contrary to above, change the phase wire of
the motor.
l Connect the ground wire to ground.
l In the operation, the turntable generally turns
clockwise, only when the operation is obstructed
occasionally, it needs to turn counter-clockwise.
Bead Breaker
l The bead breaker is on the right side of the
cabinet. As the procedure requires, press down
pedal (I) (Fig.17)o start the bead breaker cylinder,
the piston rod will pull the bead breaker moving
towards the cabinet, with magnitude around
14075N. Release pedal (I), the bead breaker
will retract.
l
The bead breaker is able to swing within a
certain range. In case the range of swing is not
appropriate, adjust the nut (Fig.18)at the right
end of the piston rod.
l The bead breaker arm is adjustable with two
ranges. According to the size of tyre, choose
range 1 or range 2. (Fig.19)
Fig.17
Fig.18
Fig.19
Tilting column Unit
l
The tilting column is under the control of tilting
cylinder in the cabinet, so that the column can tilt
backward in order to remove the tyre from the
turntable easily, and restore to upright position
(the working position).
l The tilting cylinder is controlled by pedal G
When it is pressed, the tilting column tilts
backward; and when it is pressed again, the
column restore to the upright position (Fig.20)
l If tilting speed is too fast or too slow, adjust the
throttles to change speed. If the speed is too fast,
fasten the screw on throttle mouth. If too slow,
loose the screw. The 5-way valve has two
throttles(Fig.21, of which
“ a ” is for tilting
backward while “ b ” is for back to upright position.
Fig.20
Fig.21
l
There are two bolts on the base plate of the tilting
column to adjust the vertical position of the tilting
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn