Lauda PROLINE P 5 C, Руководство по эксплуатации

Страница: 42 / 120

42 / 123 Proline heating thermostat 02/2022
Command
Pump level

Open the device parameter menu via the soft
key Menu .

Change from Pump

Pump level using .

With or you enter the illustrated win-
dow.
Level 5 is active.

Select another pump level with or and
confirm with or End ,
 or quit the window with without making any
changes.
Standby activation
+

Standby activation
(Pump and heater are deactivated when the
green LED in the lower part of the key is lit).
Please exercise caution when thermostat is in standby mode.
The following settings/ actions may start the thermostat unintentionally from the standby mode:
 A previously activated timer mode (

7.12), because a started time continues to run.

"Start" command via interfaces (

8).
7.7.4 Activating external control
An external temperature probe can be connected to the Proline Thermostats. How this is done is explained in Section
7.7.2. If the set point temperature is to be controlled using this sensor instead of the internal sensor, the setting can be
made here.
Furthermore, control can also occur based on the signal from the analog or serial module (

4.8).
Master
Con
and 2 x
Call the source selection for the control
Con
.

The momentary setting for the source is displayed,
 here
1
for internal, because control takes place using the temperature signal
from the internal temperature probe.
 The source display flashes.
Pump Menu End T
set
T
fix
Level 8
Level 7
Level 6
Level 5
Level 4
Level 3
Level 2
Level 1
Pump level
Con 1
°C