23
MachXO2280 Breakout Board Evaluation Kit
Glossary
PLD
: Programmable Logic Device
DIP
: Dual in-line package
LED
: Light Emitting Diode.
LUT
: Look Up Table
PCB
: Printed Circuit Board
RoHS
: Restriction of Hazardous Substances Directive
USB
: Universal Serial Bus
WDT
: Watchdog Timer
Troubleshooting
Use the tips in this section to diagnose problems with the Breakout Board.
LEDs Do Not Flash
If power is applied but the board does not flash according to the preprogrammed counter demonstration then it is
likely the board has been reprogrammed with a new design. Follow the directions in the
Demonstration Design
sec-
tion to restore the factory default.
USB Cable Not Detected
If ispVM System does not recognize the USB cable even after installing the Lattice USB port drivers and rebooting,
the incorrect USB driver may have been installed. This usually occurs if you attach the board to your PC prior to
installing the USB driver or ispVM System software.
To access the Troubleshooting the USB Driver Installation Guide:
1.
Start ispVM System and choose
Options > Cable and I/O Port Setup
.
The Cable and I/O Port Setup Dialog appears.
2.
Click the
Troubleshooting the USB Driver Installation Guide
link.
The Troubleshooting the USB Driver Installation Guide document appears in your system’s PDF file reader.
3.
Follow the directions of the guide to install the Lattice USB driver.
Determine the Source of a Pre-Programmed Device
You may receive your Breakout Board after it has been reprogrammed by someone else. To restore the board to
the factory default, see the
Download Demo Designs
section for details on downloading and reprogramming the
device.
You can also determine which demo design is currently programmed onto the Breakout Board by comparing the
JEDEC checksums against of the programming file with what is read from the programmed device.
To compare JEDEC file checksum:
1.
Connect the Breakout Board to a host PC using the USB port.
2.
Start ispVM and choose
ispTools > Scan
.
The device appears in the Device List.
3.
Double-click the device row.
The Device Information dialog appears.
