LaTrax TETON 76054-5, Руководство пользователя

Страница: 10 / 19

10
RADIO SYSTEM RULES
• The 2.4GHz transmitter has a directional antenna.
For maximum range, hold the transmitter upright and
pointed in the direction of the model. Pointing the
transmitter away from the model will reduce radio range.
• Always turn your transmitter on first and off last. This
procedure will help to prevent your model from receiving
stray signals from another transmitter, or other source,
and running out of control. Your model has electronic
failsafes to prevent this type of malfunction, but the first,
best defense against a runaway model is to
always turn
the transmitter on first and off last.
• Always use new or freshly charged batteries for the
radio system. Weak batteries will limit the radio signal
between the receiver and the transmitter. Loss of the
radio signal can cause you to lose control of your model.
• In order for the transmitter and receiver to bind to one
another, the receiver in the model must be turned on
within 20 seconds of turning on the transmitter. The
transmitter LED will flash fast red, indicating a failure to
link. If you miss it, simply turn off the transmitter and
start over.
• DO NOT CUT any part of the receiver’s antenna wire.
Cutting the antenna will reduce range.
THE 2.4GHz RADIO SYSTEM
Steering
Trim
Steering Wheel
Power
Switch
Battery Compartment
Set Button
Red/Green
Status LED
TRANSMITTER
RADIO SYSTEM WIRING DIAGRAM
Antenna
Receiver
CH1 - Channel 1*
CH1
- Steering Servo
CH2 - Electronic
Speed Control
CH3
- Channel 3*
Motor
Battery Connector
(Male)
to battery
Channel 2
Electronic
Speed Control
Channel 1
Steering Servo
*Not used
Throttle Trigger
When rechargeable batteries begin to lose their
charge, they will fade much faster than alkaline dry
cells. Stop immediately at the first sign of weak batteries.
Never turn the transmitter off when the battery pack is
plugged in. The model could run out of control.
Always turn your
transmitter on first.
Plug in the battery. Turn on the model.