background image

4

           

                                                          

Your model is able to use    

                  LiPo batteries. Charging and discharging 
batteries has the potential for fire, explosion, serious 
injury, and property damage if not performed per 
the instructions. Before use, read and follow all 
manufacturer’s instructions, warnings, and precautions. 
In addition, Lithium Polymer (LiPo) batteries pose a 
SEVERE risk of fire if not properly handled per the 
instructions and require special care and handling 
procedures for long life and safe operation. LiPo 
batteries are intended only for advanced users that are 
educated on the risks associated with LiPo battery use. 
Traxxas does not recommend that anyone under the 
age of 14 use or handle LiPo battery packs without the 
supervision of a knowledgeable and responsible adult. 
Dispose of used batteries according to the instructions.

Important Warnings for users of Lithium Polymer (LiPo) 
batteries:

• LiPo batteries have a minimum safe discharge voltage 

threshold that should not be exceeded. The electronic 
speed control is equipped with built-in Low-Voltage 
Detection that alerts the driver when LiPo batteries 
have reached their minimum voltage (discharge) 
threshold. It is the driver’s responsibility to stop 
immediately to prevent the battery pack from being 
discharged below its safe minimum threshold.

• Low-Voltage Detection is just one part of a 

comprehensive plan for safe LiPo battery use. It is 
critical to follow all instructions for safe and proper 
charging, use, and storage of LiPo batteries. Make 
sure you understand how to use your LiPo batteries. If 
you have questions about LiPo battery usage, please 
consult with your local hobby dealer or contact the 
battery manufacturer. As a reminder, all batteries should 
be recycled at the end of their useful life.

•  ONLY use a Lithium Polymer (LiPo) balance charger 

with a balance adapter port to charge LiPo batteries. 
Never use NiMH or NiCad-type chargers or charge 
modes to charge LiPo batteries. DO NOT charge with 
a NiMH-only charger. The use of a NiMH or NiCad 
charger or charge mode will damage the batteries and 
may cause fire and personal injury.

•  NEVER charge LiPo battery packs in series or 

parallel. Charging packs in series or parallel 
may result in improper charger cell recognition 
and an improper charging rate that may lead to 
overcharging, cell imbalance, cell damage,  
and fire. 

FIRE HAZARD!

WARNING!  CAUTION!  DANGER!

•  ALWAYS inspect your LiPo batteries carefully 

before charging. Look for any loose leads or 
connectors, damaged wire insulation, damaged cell 
packaging, impact damage, fluid leaks, swelling 
(a sign of internal damage), cell deformity, missing 
labels, or any other damage or irregularity. If any of 
these conditions are observed, do not charge or use 
the battery pack. Follow the disposal instructions 
included with your battery to properly and safely 
dispose of the battery. 

•  DO NOT store or charge LiPo batteries with or around 

other batteries or battery packs of any type, including  
other LiPos.

•  Store and transport your battery pack(s) in a cool 

dry place. DO NOT store in direct sunlight. DO NOT 
allow the storage temperature to exceed 140°F or 
60°C, such as in the trunk of a car, or the cells may 
be damaged and create a fire risk. 

•  DO NOT disassemble LiPo batteries or cells.
•  DO NOT attempt to build your own LiPo battery 

pack from loose cells.

Charging and handling precautions for all battery types:

• Use the supplied NiMH charger to charge the 

included battery. DO NOT attempt to charge LiPo 
batteries or any other type of battery with this 
charger.

• BEFORE you charge, ALWAYS confirm that the 

charger settings exactly match the type (chemistry), 
specification, and configuration of the battery to be 
charged. 

• DO NOT attempt to charge non-rechargeable batteries 

(explosion hazard), batteries that have an internal 
charge circuit or a protection circuit, batteries that have 
been altered from original manufacturer configuration, 
or batteries that have missing or unreadable labels, 
preventing you from properly identifying the battery 
type and specifications.

• DO NOT exceed the maximum manufacturer 

recommended charge rate.

• DO NOT let any exposed battery contacts or wires 

touch each other. This will cause the battery to short 
circuit and create the risk of fire.

• While charging or discharging, ALWAYS place the 

battery (all types of batteries) in a fire retardant/fire 
proof container and on a non-flammable surface 
such as concrete.

(continued on next page)

INTRODUCTION

NiMH battery charger*

Содержание 75064-5




















Отзывы: