2000 – 4000 Series Time Recorder User’s Guide
Page
10
Replacing the Type Section
If your type section needs servicing, you can easily remove and replace
it without sending the entire machine for service.
Figure 8
1.
Remove the top cover.
2.
Remove
Type Section Retaining Ring and Washer– Figure 8,
8.1
.
3.
If the type section has digital time display, unplug connectors
(not shown).
4.
Lift type section slightly and move it to the right to release
Hinge Pins – Figure 8, 8.2
from their sockets. The Type
Section will lift out.
2000 – 4000 Series Time Recorder User’s Guide
Page 3
Raise the Type Section
1.
Unlock the case cover and pull it forward to remove it.
2.
Note the position of the Release Latch and Face Setting Wheel
used later in this process.
3.
Wait until you hear the clock “click”.
4.
Press either side of the
Type Section Headlock – Figure 1, 1.2
and pull upward on the lower part of the Clock Face until the
Type Section locks in the up position as shown in
Figure 1
.
Note position of the Overthrow Lever and the Setting Wheel.
5.
Press the red
Overthrow Lever – Figure 1, 1.3
away from you
until it clicks. This releases the wheels allowing them to turn.
Set the Time on the Type Wheels
Figure 2
1.
Locate the Center Line where all the wheels line up as shown in
Figure 2
.
2.
Rotate the wheels using a pointed object. Rotate each wheel
until the correct date and time are aligned at the Center
Position, as shown in
Figure 2
.
Hint: Start at the top wheel
and work down when setting.