Initial Set-Up
Mower Deck Height
Initial Set-Up
9/27/19
3-12
3
a.
Arms should also “snap” back to neutral posi-
tion, which is straight up and down and cen-
tered with the neutral position lock (notch in the
frame).
4.
Ensure to return and lock both control arms into neu-
tral position.
The control arms can be adjusted for operator comfort
by repositioning the control arms on the control assem-
bly. See Figure 3-6.
3.17 Mower Deck Height
Do not attempt to change the cutting
deck height while the engine is running.
Set the deck height before operating your Articulator.
Your Articulator has a mower deck height range of 1"
to 4.5", in 1/4" increments. The mower deck height
adjustment has a lever for adjusting the deck height.
The lever fits into spaces marked off in 1/4” spaces,
and are marked at the 2", 3", and 4" deck height positions for quick identification.
1.
Pull the deck height control lever out from the height bracket and move it to the desired
height.
2.
Replace the lever into the bracket. See Figure
3-7.
3.
This sets the entire cutting deck to the desired
height.
3.18 Mower Deck Height Calibration
Do not make any adjustments
to the deck height while the
engine is running.
CM0075-2
FIG. 3-6
CM003
FIG. 3-7