Lastec Articulator 325D, Руководство пользователя

Страница: 31 / 48

Initial Set-Up
Tires & Wheels
Initial Set-Up 325D/425D/Odoc082200 3-15
3
adjusted, tighten both rear nuts to lock them into place.
8. To adjust the cable on the foot pedal, use the same procedure as the rocker. When
standing in front of the foot pedal, turning the rear cable nuts counter-clockwise will raise
the deck, clockwise will lower it.
9. Re-measure the fronts of all decks. They should all measure 2”, +/- 1/8”, from the bottom
of the pan to the floor. If any deck does not fall within this range, repeat the cable adjust-
ment procedures for that deck.
10. Once the fronts of the decks are adjusted, you must adjust the rear of the decks to mea-
sure between 2” and 2 1/2”.
11. Loosen the lock nut on the tie rod running from deck 2 to the rear dual wheel axle.
12. From in front of the deck, turn the tie rod counter-clockwise to raise the decks, clockwise
to lower them. Adjust the tie rod until the rears of all decks measure between 2” and 2
1/2”.
13. Tighten the tie rod lock nut.
14. Re-measure all decks, and repeat adjustment procedures if necessary.
3.24 Tires & Wheels
Check the air pressure in the pneumatic drive tires. Proper air pressure is 10 PSI.
Check the air pressure in the pneumatic front tires. Proper air pressure is 20 PSI.
Check the air pressure in any pneumatic (non-urethane filled) gauge tires. Proper air
pressure is 50 PSI.
Verify proper function of all mower deck gauge wheels. The wheels should turn freely
without excessive side-to-side motion, and be free of debris. Clean, adjust, replace, and
grease as necessary.
Check that each wheel swivels freely in the shaft pivot collar, and the bushings are in
good condition. If any wheel does not swivel freely, clean and grease the shaft collar
assembly. Replace the bushings if necessary.
3.25 General
Verify that all warning decals are in place, visible and legible.
Verify that all covers and safety devices are properly installed and secure.
Check that the discharge chute is clear of debris, properly mounted, and in good condi-
tion.
Inspect entire Articulator for loose or entangled parts, debris, obstructions, neglected
tools, or any other possible safety hazards, equipment hazards or projectile hazards.
Go to www.lastec.com for latest changes in this manual.