Lastec 721XR, Руководство пользователя

Страница: 36 / 56

Initial Set-Up
Deck Belts and Alignment
3
3-12 Lastec//092215 Initial Set-Up
the slide bar, loosen the jam nut and adjust the bolt in or out of the slide bar. DO NOT
TIGHTEN THE BOLT HEAD AND NYLOCK NUT AGAINST THE ADJUSTMENT PLATE
ON THE DECK. MAINTAIN 1/32” GAP BETWEEN PLATE AND WASHERS TO ALLOW
THE DECK TO FLOAT PROPERLY WITHOUT PLACING EXCESS STRESS ON THE
SLIDE BAR.
4. Align the front three decks (decks 1, 2, and 3). Adjust the pivot slide bars located on the
main deck common legs. Adjusting the slide bar in swings the outer front deck outward
away from the main deck. Adjusting the slide bar out swings the outer front deck inward
toward the main deck. Align the decks so that the wheels are parallel to one another and
aligned with the tractor tires. Wheel misalignment causes premature wear and wheel fail-
ure.
5. Align the outside two decks (decks 6 and 7). Adjust the tie rod located under the hydrau-
lic cylinder on each deck. Adjusting the tie rod out swings the deck back, adjusting it in
swings the deck forward. Adjust the tie rods so that the slide bars are centered within the
belts.
6. Tighten all slide bar jam nuts.
7. Clean each entire deck area (under the belt covers) of all excess grease, oil, fuel, grass,
or debris before operating the Articulator. This will help prevent damage to the equip-
ment, fire hazard, and projectile hazards.
8. Be sure to replace all belt covers and hardware.