Lastec 325EFR-H, Руководство пользователя

Страница: 22 / 32

Initial Set-Up
Mower Deck Height
Initial Set-Up 325EFRH/Odoc061600 3-6
3
3.6 Mower Deck Height
The Model 325EFR-H Articulator has a standard mower deck height range of 1" to 4 1/2",
in 1/4" increments. If you wish to change the deck height, do so before attempting to
operate the Articulator.
The deck height adjustment lever has (1) permanently fixed spacer, and (16) adjustable
spacers, each equal to 1/4" deck height adjustment. The deck is at its minimum height
(1") when only the fixed spacer is in front of the lever lock bracket. Each adjustable
spacer placed in front of the lock bracket raises the deck height by 1/4”, up to 4 1/2". The
spacers which mark the 2", 3", and 4” deck height positions are knurled for quick identifi-
cation. To adjust the mower deck height:
1. Disengage the PTO.
2. Tighten both deck limit chains, and secure the snap links.
3. Lift the mower deck to transport position.
4. Secure the deck service safety latch.
5. Turn the spacer locking knob on the height adjustment lever counter-clockwise until the
spacers and lever are loose. Raise the lever from the locking bracket and adjust the
spacers to the desired height setting. Each spacer placed in front of the lock plate will
indicate an additional 1/4” of deck height. When the desired deck height setting is
reached, place the lever back into the locking bracket and turn the spacer locking knob
clockwise until the spacers are tight. Avoid trapping fingers between the spacers and the
lock plate during adjustment. Repeat process on all three deck height adjusting rods.
6. Disengage the deck service safety latch.
7. Lower the mower deck to the ground.
8. Loosen both deck limit chains, and secure the snap links.
NOTE: An additional 1/4” of deck height can be attained, for a maximum height of 4 3/4”,
by removing the 1/4” spacers from ABOVE all the wheel yoke collars and placing them
BELOW the collars. This will raise all of the deck height settings obtained with the deck
height adjusting lever by 1/4” respectively.
NEVER attempt to change the cutting deck height while the engine is
running!
Go to www.lastec.com for latest changes in this manual.