3 - Setting Up Your Machine
3.4 - Assembly and Installation of the Back-gauge
Page 07
3.4.1
Diagram 3-50
Assemble the Backgauge by placing the Black Fiber Washer (EBM-76) over the Threaded Stud. Place the Clamp
Bracket (EZ-1028) on the Threaded Stud with the knob end toward the center of the assembly. Tighten the Elastic
Stop Nut on the Threaded Stud with a wrench until it is snug, allowing the Clamp Bracket to move with slight resis-
tance.
Clamp Bracket & 1/4” Knob
Black Fiber Washer
5/16”-18 Elastic Stop Nut
Threaded Stud
Attach the Backguage to the Table by hooking the left end over the
Side Iron (FM4-4003) on the side as shown in the accompanying
picture. Align both ends of the Backgauge using the Table Scales
(3S-14) so that it is squared correctly. When it is positioned as
desired tighten down the Clamp Bracket Knob as shown.
Do not position the Backgauge too close to the hollow drill bit so
that it touches. This can cause serious damage to the hollow drill
bit causing it to break or shatter. The Backgauge must be at least
1/8” from the circumference of the hollow drill bit.
3.4.2
3.4.3
Diagram 3-60
Diagram 3-70
3.5 - Installing the Paper Side Stops
3.5.1
Attach the Paper Side Stops (FM4-4006) using two (2) Side Stop
Screws (FM4-4007) each. Position the Paper Side Stop as de-
sired and tighten down with light pressure.
Diagram 3-80
