Page 03
Corner Rounding Operation
Place the product you are cutting onto the Wooden Top Plate and push it into the corner
aligning it with the Side guide the the back edge of the Cutting Unit.
Press down firmly to prevent the product from sliding out of the corner.
Depress the Handle with an even consistent pressure until the knives cut through the
product.
These size Cutting Units were designed to handle up to a 1/2” stack of paper. They will also
cut many other materials such as plastics, cardboard, celluloid, leather, wood, and even
light soft metals. With heavier materials, however, best results may be obtained if only one
or a few pieces are cut at a time.
These size Cutting Units were designed to handle up to a 1/8” stack of paper. They will also
cut many other materials such as plastics, cardboard, celluloid, leather, and wood. With
heavier materials, however, best results may be obtained if only one or a few pieces are cut
at a time.
Cutting Unit Capacities
Standard / Special Size Cutting Units:
Large Size Cutting Units:
Chip Removal
Pull out on the Chip Tray Handle located on the back of the machine and emtpy the
contents of the Chip Tray. Replace the Chip Tray by inserting the flanges into the retainer
strips located on the underside of the Wooden Top Plate.
Note:
It may be necessary to adjust the Side Guide to compensate for variation in the cutting unit geometry,
especially when changing from a Standar / Specail Size Cutting Unit to a Large Size Cutting Unit.
Note:
Do not allow chips to build up under the Cutting Unit. Occasionally tilt the back of the machine up to
allow the paper chips to flow to the extreme end of the chip box. Empty the Chip Tray as needed.
