485 Hague Street, Rochester, NY 14606 U.S.A.
Tel: 585-436-1934 Fax: 585-464-8665
www.lasscowizer.com [email protected]
Cutting
After the machine has been properly aligned you are ready to cut:
Place the product you are cutting on the surface of the machine. Please
note that this machine can only handle up to a maximum of 1” of product.
This amount will vary depending on what you are cutting. Please test on
scrap.
Hold the product firmly in place keeping it square using the Side Guides.
Bring the Handle straight down with firm pressure so that the Blade moves
through the product smoothly.
1.
2.
3.
Tips on Cutting
Occasionally, the bottom sheet may not cut. If this occurs, place a piece of
card stock underneath the stack you are cutting. This will give support to the
product you are cutting.
When cutting business cards or other small sizes, the bottom card may slide
forward. Try either cutting a smaller stack, place a piece of card stock
underneath the stack, or both.