Locate Hardware Bag “D” to Assemble Wheels to
Base.
(Figures 2 and 3)
1. Remove Wheel Assemblies from Hardware Bag “D”.
2. Take note that Wheel Assemblies are
RIGHT
and
LEFT
handed.
(Figure 3)
3. Place one Wheel Assembly on Base location
as shown.
4. Align two bolt holes and insert 5/16 - 18 X 1”
Long Carriage Bolt.
(Figure 2)
5. Tilt Base and Secure one bolt at a time by first put-
ting on a 5/16 Split Lockwasher and then a 5/16-18
Hex Nut.
6. Repeat steps 2 thru 5 with other Wheel Assembly.
Locate Hardware Bag “A” to Assemble Base.
(Figure 1)
1. Place
Base
on floor.
2. Fit
Mounting Flange
through large hole in center of
Base
.
3. Insert (4)
3/8-16 X 1” Carriage Bolts
through
Mounting
Flange
and
Base
.
4. Tilt
Base
and secure one
Carriage Bolt
at a time by first
putting on a
3/8” Split Lockwasher
and then a
3/8-16 Hex
Nut
. DO NOT FULLY TIGHTEN AT THIS TIME. Repeat above
procedure with remaining Bolts.
5.
GO BACK AND FULLY TIGHTEN
each
Hex Nut
so that the
Flange
is securely assembled to the
Base
.
6. Thread the
3/8-16 X 1” Square Head Bolt
into the
Mounting
Flange
.
WHEELS TO BASE ASSEMBLY
BASE ASSEMBLY
Rev. E 8/10
3
5084445
Figure 1
Mounting Flange
Carriage Bolts (4)
Square Head
Bolt
Base
Hex Nut (4)
Split Lockwasher (4)
INCORRECT
CORRECT
Figure 2
Figure 3