Rev. E 10/10
2
2137ES
Rev. E 10/10
7
2137ES
MODELO 2137
FUNCIONAMIENTO
1. Cuidadosamente retire el Ventilador de la bolsa plástica y la
caja.
Asegúrese que el enchufe encaje firmemente en el
tomacorriente.
Cuando los enchufes quedan flojos en los
tomacorrientes, pueden deslizarse parcial o
completamente fuera del tomacorriente con un leve
movimiento del cable adosado. Los tomacorrientes
en este estado podrían sobrecalentarse y representar
un grave peligro de incendio; si está cubierto por una
cortina o tela, el riesgo de incendio es aún mayor.
2. Asegúrese que el interruptor de encendido se encuentre en la
posición de APAGADO.
3. Conecte a un tomacorriente de 120 voltios AC.
4. Deslice el interruptor de encendido hasta la velocidad deseada.
ALTA(2), BAJA(1)
ADVERTENCIA: ASEGÚRESE DE QUE EL VENTILADOR
ESTÉ APAGADO ANTES DE INVERTIR LA UNIDAD EN
LA VENTANA.
5. Cuando se invierte el ventilador en la ventana, éste sacará el
aire viciado en la habitación hacia el exterior.
INSTALACIÓN PARA VENTANA DE DOBLE
ABERTURA
(Figura 1)
Recomendamos mantener la malla de la ventana en su lugar.
1. Centre el ventilador en la ventana, tire de los paneles expansibles
hacia afuera para hacerlos encajar con seguridad en el riel de
la ventana.
2. Baje la ventana y asegure detrás del sujetador de la ventana
encima del ventilador.
PARA VENTANAS VERTICALES CORREDIZAS
y VENTANAS DE MARCO GIRATORIO:
Recomendamos mantener la malla de la ventana en su lugar.
1. Coloque el ventilador en la ventana con el interruptor apuntando
hacia el centro de la abertura.
2. El ventilador debe encajar con seguridad contra el borde interno
de la abertura de la ventana.
3. Deslice la ventana corrediza hasta tocar el borde del ventana. El
borde lateral de la ventana debe encajar con seguridad detrás
del borde de la caja del ventilador.
4. Para ventanas de tamaño superior a 35" (889 mm), construya un
panel de madera contrachapada que encaje en el área abierta
y asegure el ventilador al marco de la ventana.
5. En ventanas con marco giratorio que tengan un ancho superior
a 12" (304,8 mm), será necesario construir una estructura de
madera contrachapada alrededor del ventilador y luego asegurar
la estructura al ventilador y al marco de la ventana.
Figura 1
Panel Expansible
de Ventana
Panel Expansible
de Ventana
Sujetador de
Ventana
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electrical shock and injury to persons, including the following:
SAVE THESE INSTRUCTIONS
Read all instructions before using this Fan.
1. Make certain the power source conforms to the electrical requirements of the Fan.
2. Make certain that the room is equipped with a working smoke detector.
3. Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock,
or injury to persons.
4. To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it.
5. Unplug power cord before installing, servicing, or moving the Fan.
DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN SERVICING
OR MOVING THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE
LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN.
6. This Fan must
NOT
be used in potentially dangerous locations such as flammable, explosive, chemical-laden or wet atmospheres
where gasoline, paint or flammable liquids are used or stored.
7. This Fan is rated for use as a Window Fan, however, we recommend that during rain, this Fan be removed from the window.
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK - DO NOT USE THIS FAN
WITH ANY SOLID STATE SPEED CONTROL DEVICES.
8. Where possible, avoid the use of extension cords because the extension cord may overheat and cause a fire. If you must use an exten-
sion cord, minimize the risk of overheating by using the shortest cord possible and ensuring that it is UL listed. NEVER use a single
extension cord to operate more than one Fan.
DO NOT
plug Fan into any other cord connected device, such as a power strip, cord
reel, surge protector, mutiple outlet adapters or outlet-type air fresheners. The use of such devices may create a fire hazard.
9.
NEVER
operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or damaged in any manner.
10.
NEVER
insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire,
or damage the Fan. To reduce the risk of fire,
DO NOT
block or tamper with the Fan in any manner while it is in operation.
11. Always place the Fan on a stable, flat, level surface when operating, to avoid the chance of the Fan overturning. Locate the Power
Cord so the Fan or other objects are not resting on it. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be
tripped over.
12. This Fan is not intended for use in wet or damp locations. Never locate a Fan where it may fall into a bathtub or other water container.
NEVER
use Fan where flammable liquids are used or stored.
13.
NEVER
use Fan outdoors.
14. This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please
refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical require-
ments for Agricultural Buildings.
THIS FAN DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
15. This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or
local codes or standards relating to electrical requirements for Hazardous locations.
THIS FAN DOES NOT MEET THE REQUIRE-
MENTS OF NEC ARTICLE 500 (2008).
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug
is intended to fit in a polarized outlet only one way. Match wide blade of plug to wide slot. Fully insert. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat
this safety feature.
Figura 2
INSTALACIÓN DE LAS PATAS (Figura 2 )
Cuando utilice el ventilador como un ventilador de piso o
mesa, coloque las dos (2) patas en su lugar al deslizarlas en la
parte inferior hasta que queden sujetadas.
ADVERTENCIA: Asegúrese de que las patas no estén
colocadas cuando utilice el ventilador en una ventana.
Vista del inferior del ventilador
Patas
parte trasera
del ventilador
This plug is a safety feature. It contains a safety device (fuse) that should not be removed. Discard product if the at-
tachment plug is damaged. To reduce the risk of fire, electric shock and personal injury, DO NOT remove, replace,
repair or tamper with the originally supplied plug. If the Fan does not function properly, it may be due to the safety
device incorporated in this plug. Call 800-233-0268, Monday - Friday, between 8:00 a.m. and 5:00 p.m. Eastern. If the
plug warning label is missing or damaged, call the toll free number for a replacement label.
