Manual / Bedienungsanleitung: ES-400 G
Version / Stand: 12/2010
Page / Seite 5 of / von 10
0010 0100 01, DMX mode address 36 (0+0+4+0+0+32+0+0+0)
DMX control
Channel
Value
Function
1
0..30
Laser off
Beam patterns
31..61
DMX beam pattern model
62..92
DMX show editing model
93..123
DMX show automatic model
124..154
DMX show music control model
Graphics
155..185
DMX animation patterns model
186..216
DMX animation editing model
217..247
DMX animation automatic model
248..255
DMX animation music control model
2
Multi channel
1..255
Pattern model: pattern A selection
0..255
Show model: show selection
3
Multi channel
1..255
Pattern model: pattern B selection
0..255
Show model: show selection
4
Pattern C selection
1..255
Pattern C selection
5
Pattern D selection
1..255
Pattern D selection
6
Multi channel
0..51
A,B,C,D pattern control simultanously
52..103
Pattern A control
104..155
Pattern B control
156..207
Pattern C control
208..255
Pattern D control
0
Laser show part editing off
1..255
Laser show part editing
7
Rotation
0
No effect
1..127
Rotate by angle
128..191
Rotate counterclockwise
192..255
Rotate clockwise
8
Vertical rotation
0
No effect
1..127
Static
128..255
Dynamic
9
Horizontal rotation
0
No effect
1..127
Static
128..255
Dynamic
10
Move
0
No effect
1..127
Move horizontal (incr. Speed)
128..255
Move vertical (incr. Speed)
11
Part drawing
0..41
Draw partly in
42..83
Draw partly out
84..127
both
128..255
Dot effect
12
Vertical position
0
No effect
1..255
Vertical position
13
Horizontal position
0
No effect
1..255
Horizontal position
14
Zoom in/out
0
No effect
1..127
Zoom
128..169
Zoom out (incr. Speed)
170..211
Zoom in (incr. Speed)
212..255
Zoom in/out (incr. Speed)
15
Speed
0..255
Channel 11-14, show speed adjustment
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing screws on side panels, 2 feet on bottom on one side, and back panel,
remove connector to front panel, then slide out mounting plate – be careful with cables. Remove any
deposits of dust, especially at the fan. Check for condensed fog fluid inside, if so, clean and
rearrange the position of laser and or hazer.
Mirrors need cleaning, when a “halo” is noticeable
around the beam, or an unusual high amount of diffuse light can be seen inside the device.
Clean the
mirrors with window cleaner and a paper towel.
