LaserMech FiberMINI 2.0, Руководство по эксплуатации, Страница: 35 / 54

PLMNL0286 REV. B, Effective Date: 06/06/19
30
FiberMINI
®
with Auto Focus (AF) Operation Manual
4.5.3 Positioning
For steps 1 and 2, see Figure 31 .
1. Click the Settings button ( ) in
the toolbar and hover over
Positioning .
2. Click Focus Position, Enable
Step/Direction, Invert Direction*,
Maintain Ready*
or Step Size* , as
desired.
Figure 31
Items noted by an asterisk (*) only
appear when Step/Direction is
enabled.
3. If you select Focus Position or Step
Size , perform steps 3 to 6 in
Section 4.5.2 .
4.5.4 Height Sensor
For steps 1 and 2, see Figure 32 .
1. Click the Settings button ( ) in
the toolbar and hover over Height
Sensor .
2. Click Active Curve, Averaging,
Gain Factor or Disable HSU , as
desired.
The choices in step 2 only appear
when the height sensor is
enabled.
Figure 32
3. If you select Active Curve , a dialog
box will appear, see Figure 33 .
Figure 33
a. Click the left or right arrows to
select the desired curve.
b. Click OK .
c. If necessary, click Cancel to
exit the screen.
4. For other parameters, perform
steps 3 to 6 in Section 4.5.2 .