EasyCross-Laser Green
09
2
Horizontal and vertical levelling
Release the transport restraint, push the slide
switch (3) to the left. The laser lines can be switched
individually with the selection button.
EN
1
5
2
3
a
b
4
1
2
3
4
5
LED levelling
LED flashing: levelling off
LED on: levelling on /
ON/OFF button
Battery compartment
(backside)
Slide switch
a
ON
b
OFF / transport lock /
slope mode
Laser output windows
1/4“ tripod threads (bottom)
The transport restraint must be released for horizontal and
vertical levelling. The LED (1) shows a permanent green light.
The laser lines flash as soon as the device is outside the auto-
matic levelling range of 3°. Position the device such that
it is within the levelling range. The light of the laser linesis
constant again.
!
3
Preparing the calibration check
It is possible for you to check the calibration of the laser. To do this,
position the device
midway
between 2 walls, which must be at least
5 metres apart. Switch the device on
(LASER CROSS ON).
The best
calibration results are achieved if the device is mounted on a tripod.
Do not release transport restraint, push slide switch (3)
to the right. Sloping planes can now be measured.
This mode cannot be used to perform horizontal or
vertical levelling as the laser lines are no longer aligned
automatically. LED (1) and the laser lines flash green.
Slope mode
