LaserLine MultiMeter-Home, Руководство по эксплуатации

Страница: 15 / 68

MultiMeter-Home
15
200
3
2
Voltage measurement DC
To measure voltage, set the rotary
switch to the “
“ position with
the corresponding measuring range
(12 V - 300 V).
Then connect the measuring contacts
to the object to be tested.
Reading the scale (B):
If the pointer remains to the
left of the “0“ during the
measurement or to the right
of the “0“ when measuring
resistance, either the test prods
are mixed up or the measuring
circuit is interrupted. Repeat
the measurement with the test
prods changed over. The measuring range is exceeded
if the pointer remains to the
right of “300“ (“60“ / “12“)
or to the left of “1 kΩ“ when
measuring resistance. Repeat
the measurement with a higher
measuring range.
Notes on measurement
Before each measurement, check that the pointer is set exactly
to „0“ on the
/ -scale (B/C). If not, adjust the pointer
with rotary knob (2).
If the value of the measured variable is not known in advance,
set the rotary switch to the highest measuring range.
Then reduce the measuring range step by step until a satisfactory
resolution is achieved.
red black
Be sure to pay attention to polarity.
GB
12 V
60 V
120 V
300 V
0 - 12
0 - 60
0 - 12
0 - 300
x 1
x 1
x 10
x 1
Result Scale
Measuring
range