3
CONTROL PANEL
1
Main Power Switch
with status light above.
Turn on first thing, leave on entire shift.
2
Laser Mode Switch
with status light above.
1st depression = Laser on steady.
2nd depression = Laser on blinking.
3rd depression = Laser off.
3
Deicer Switch
(winter operation only)
with status light above.
Turn on first thing, leave on entire shift.
4
Power Cable to Vehicle 12 or 24 VDC
White wire positive.
Black wire to ground.
Note: Attach to minimum 10 amp
circuit using minimum 16 gauge wire.
5
Laser Control Cable
6
Plow Position Sensor Wire
Connects to the hot wire on “power
up gravity down” systems for the
wing plow control. Call factory for other
installation possibilities. If not used,
cut wire off and tape or shrink tube
the end.
GL3000PMC LASER ASSEMBLY
6
Vertical Aiming
Loosen to aim; retighten.
7
Horizontal Aiming
Loosen to aim, retighten.
8
Mounting Holes
for Laser Module (2 Each).
9
Laser Beam Exit Window and Front Panel
(Automatically heated).
10
Pneumatic Snow Removal Module
Sends air blast automatically every 5 seconds
to front to Laser Exit Window (
9)
.
11
90° Adjustable Air Delivery Nozzle
12 Connector for Pneumatic Hose
13 Mil Spec Connector
at rear of laser
for Laser Control Cable (
5).
14
Purge Valve Set at factory
Do not break seal or tamper
with as it can damage the unit
and void the warranty.
OPERATOR CONTROLS
START UP PROCEDURE (WINTER)
A Turn on the (1) Main Power Switch
15-20
minutes prior to plowing. This puts the laser
module in “preheat” to get the laser up to
operating temperature. The laser status light
(green light above laser mode switch) will
slow-blink until the system is warmed up, and
then go on steady when the laser is activated.
B Turn on the (3) Deicer Switch
right after you
turn on the main power switch. Leave this
switch on for the entire shift. This switch acti-
vates both the anti-ice heater on the front of the
laser module as well as the pneumatic air blast
module for snow removal from the front lens.
11
9
7
6
10
12
13
14
8
(25 feet)
(15 feet)
1
2
3
4
6
5
*Note:
