Laser BLU-BD3000, Руководство пользователя

Страница: 44 / 48

BLU-BD3000 User Manual
43 | P a g e
FAQ
In order to prolong the service life of your player, it is recommended to wait at least
30 seconds before you turn it on again after switching it off. Remove disc and turn
power off after operation. Some functions of the player may not be applicable to
certain discs.
Some discs with special features may not be fully supported by the player. This is not
a malfunction of the unit. In case of player malfunction, please turn it off, wait for 30
seconds and turn it back on.
Use the 2 charts below to resolve general operational problems. If there are any
problems that you cannot resolve, please contact Laser technical Support
Failure
Reason and solution
No power supply
Please make sure that the AC outlet has electricity.
Insert the AC power line firmly. Press the Power key on
the front panel to turn on the player.
Image is frozen and
operation is invalid
Cut off the power supply and connect again, and then
press the Power key on the remote control to restart
the player.
Auto standby
The default setting of the player: in stopped state, if
there is no operation in 5 minutes, the player enables
screen saver automatically; if there is no operation in 10
minutes in screen saver, the player enters standby
automatically. You can press the Power key on the
remote control to restart the player, or select “OFF” in
“Main menu – General – System – Screen saver”.
Remote control can’t
work normally
The remote control isn’t aimed at the receiver. Please
aim the remote control at the receiver on the front
panel.
There is obstacle between the remote control and the
player. Please remove it.
Battery is too low. Please replace with new batteries.
Please refer to the instruction of “Using remote
control”.
Can’t play discs
Please make sure that the label of the disc is upwards. If
the disc is dirty, please clean first.
The disc is empty or can’t be played. Please check
whether the area code of the disc matches the player.