13
3 Menu Appendix
.1
PRESET TITLE EDIT MODE OPERATION
Enter
into edit mode, the screen shown in figure:
From the figure we can see that the current setting is No. 1 preset point, the title is "NO TITLE".
With PAN LEFT / RIGHT to move the cursor, TILT UP / DOWN can modify the value. CLOSE
exit edit mode press the button and save the changes. Preset title can contain up to 8
characters, these characters can be 0 ~ 9, A ~ Z, +, - and blank.
3.2 MULTI-POINTS INSPECCTION EDIT MODE OPERATION
Into edit mode, the screen displays as follow:
NOTE
：
NO: tracking point number
POS: pre-setting positions number
TM: the staying time at this pre-setting position
SEQ: 01 displays the current setup is 1
CLOSE:EXIT push CLOSE to exit
The top line and bottom line show the indicating information, the middle shows every
tracking paths information. Every line shows 2 tracking points parameter. Use PAN LEFT/
RIGHT to move cursor, use TILT UP/DOWN can amend the number. Continuously push it
for one second will accelerate. Push CLOSE key-press to
exit the edit state and save the
amendment. The program will search the first POS with the position of
“000”
, and will save
the former data and treat the latter data as invalid. As the picture above, the program
saves the four tracking points. The scope of POS is 1-128. When POS is “000”, it means
the end of the tracking scope. TM’s scope is from 0 to 99 seconds.
Part
V
---Night Vision camera’s Connection Instruction
The power supply input, control signal input and video signal output uses one group of
compound cable, which will be fetched out by the seven cores aviation outlet.
Part No
Definition
Remarks
1
AC24V: Red
AC24V Input
2
AC24V: Black
AC24V Input
3
RS485-: Yellow
485 Controls B
5
RS485+: orange
485 controls A
6
Video+
video
Laser Dome Camera LD200/400 PTZ
www.laseroptronix.se
