Laser Hive G5, Инструкция по эксплуатации

Страница: 2 / 10

4. The Picture below shows an example of the material to be cut away. Note that the mesh needs
to be cut right up to the wall of the PCI compartment, one full column of holes needs to be left on
the right hand side and five colums of holes on the left hand side.
5. Make sure one row of holes remains above the top of the power plug outlet. Generally leave as
much material of the original back intact as you can.
6. Once you have made the cuts test fit the new back. This time, once you have loosely fastened
the new back plate into place offer up the G5 fan plate (with the tongue facing inwardly - i.e. the
opposite way to the original G5 fitment) to the rear of it and see if all fits well. If there is too much of
the original back to allow the fan assembly to fit, then make a note of where the problem is, take
the backplate off and do any needed extra cutting.
3. Once you have marked up the areas to be removed, you can start cutting the G5 back.
If in doubt under cut and then go back and cut more later - you can always remove
material, but putting it back is not so easy....
4. The Picture below shows an example of the material to be cut away. Note that the mesh
needs to be cut right up to the wall of the PCI compartment, one full column of holes
needs to be left on the right hand side and five colums of holes on the left hand side.
5. Make sure one row of holes remains above the top of the power plug outlet. Generally
leave as much material of the original back intact as you can.