Laser Atlanta SpeedLaser R, Руководство пользователя

Страница: 19 / 40

20
Running the Manufacturer’s Recommended Daily Tests
1) Internal Circuit Check
Press MENU followed by “A” on the keypad, which selects Test.
The LIDAR will then automatically:
a) Enter the TEST/RESET Mode
b) Restore factory default settings
c) Run the internal circuit check
d) Run the program and dynamic memory test
e) Runs an LED count test (1111, 2222, …, 9999)
f) Defaults the HUD display to 8888
Wait for when “Memory-OK” is displayed, which indicates that
the test is complete.
2) Light Segment Test
Confirm that the HUD is displaying the aiming “+” with the data
“8888”.
3) Range (Chronometer) Accuracy Test
Confirm that the LIDAR can correctly compute two or more known
ranges using any
one of the following methods:
a) From one location, range to two targets at known distances.
b) From two locations, range to one target at a known distance.
c) Range to a random target, back up a known ‘delta’ distance,
and confirm that LIDAR computes a new range with the
same delta distance. Then back up a second, but different
delta distance and confirm that LIDAR computes a new
range that matches the new delta range.
d) Combine method a) with the horizontal and vertical
alignment tests (4 and 5) on next page. This requires that the
targets used for the Horizontal and Vertical alignment are at
different known ranges.
Using your preferred method from above:
a) Stand at the selected position.
b) Aim at selected target.
c) Squeeze and hold trigger until tone sounds (range is
computed).
d) Confirm that reported range is within
±
1 foot of expected.
e) Repeat steps a) thru d) using a know distance that is at least
20 feet different then the first known distance.
Continued on next page