1706K21A
Page 3 of 26
Parameters of the display
There are three keys on the back side of the display. These keys are used to access and navigate
through the menu of the display. The identification of the keys is
Advance key. Access parameter/switch digits
Enter key. Validate parameter.
Increase key. Increase the value of the digit
Changing the time
In case the user wants to change the time, the Advance key must be pressed for three seconds.
Using the Advance (to change digit) and the Increase (to increase the value of the digit) keys the present time
can be changed. To leave the menu, press the Advance key past the digit corresponding to the units of the
minute. If the time has changed, the seconds are changed to 0 when leaving the menu. Take in consideration
that the time displayed in the menu must be UTC time. In case the display is configured to sync using the
GPS or the SNTP connection, the time inserted by the user will be overwritten.
Modify parameters
If the user presses the Advance key for 6 seconds the parameter menu is displayed. In all cases the
number the user is modifying is the one that flashes. The complete diagram of the parameters can be found in
annex 1. In order to make configuration easy for the user, when changing a parameter, a point is turned on.
This point changes depending on the sub-parameter (if it exists) the user is in.
8
.
8:88
88
:
88
8
.
8
:
88
88:8
.
8
ENTER
ENTER
ENTER
Parameters are detailed below: