1660K023G
Page 4 of 30
Changing the time
In case the user wants to change the time, the Advance key must be pressed for three seconds.
Using the Advance (to change digit) and the Increase (to increase the value of the digit) keys the present time
can be changed. To leave the menu, press the Advance key past the digit corresponding to the units of the
minute. If the time has changed, the seconds are changed to 0 when leaving the menu. Take in consideration
that the time displayed in the menu must be UTC time. In case the display is configured to sync using the
GPS or the SNTP connection, the time inserted by the user will be overwritten.
Modify parameters
If the user presses the Advance key for 6 seconds the parameter menu is displayed. In all cases the
number the user is modifying is the one that flashes. The complete diagram of the parameters can be found in
annex 1. In order to make configuration easy for the user, when changing a parameter, a point is turned on.
This point changes depending on the sub-parameter (if it exists) the user is in.
8
.
8:88
88
:
88
8
.
8
:
88
88:8
.
8
ENTER
ENTER
ENTER
Parameters are detailed below:
Parameter 1: Date configuration:
This parameter configures de date, as well as the wintertime/summertime
automatic switchover configuration. When entering this parameter, the day can be changed using the
Increase and Advance key. To switch to month configuration, press the Enter key. Navigation here is the
same as before. Once set the month, press the Enter key to switch to year configuration. Navigation here is
the same as before. Once set the year, press the Enter key to switch to the following parameter, which has
two parts:
Left digit: wintertime/summertime automatic switchover configuration
0 - Automatic switchover disabled. Time offset must be changed increasing or reducing value
in parameter 3, leaving as the internal time, the UTC time.
1 - Automatic switchover enabled.
Right Digit: Weekday.
It allows to configure the present weekday, where 1 is Monday and 7 is Sunday
